Vertmax 2.6
Problems discovered during machine warranty
Tool change
The lower tool holder is extremely unstable and the machine often drops the tool
Vertmax 2.6
Y1
When moving, the Y1 makes noise, it sounds like it is running against rubber, until we spotted metal shavings.
Vertmax 2.6
When the machine is milling
When the machine is milling, it does not press with infeed presser roller
Vertmax 2.6
When starting up
During startup, after axes reset, spindle heating cannot be performed because “Infeed presser roller different to command 2” PLC 9110
Vertmax 2.6
Front head grinding collet door open
The error occurs during tool change “Front head grinding collet door position diffenret to command” PLC 9080
Vertmax 2.6
Lack of air
There are frequent machine stops due to lack of air
Vertmax 2.6
Water splash
The water sprays all the way up onto the upper tool holder during machining
Vertmax 2.6
Front and rear red rollers, axes U
Cannot move the glass in manual mode, and if you try it makes noise especially at the beginning
Vertmax 2.6
Vertmax ONE
Problems discovered during machine warranty
Vaccum error
Poor vaccum results in the machine not starting up, after a while the vacuum can become ok and the machine can start, but often we have to start all over again. If the program requires the machine to rearrange vaccum suction cups, the same problem of poor vaccum occurs again
Vertmax ONE
Polish wheel grinding
Grinding the edges of the polishing wheel gives an inaccurate result, especially on the Vertmax one, but also on Vertmax 2.6
Vertmax ONE
Lack of air
There are frequent machine stops due to lack of air
Vertmax ONE
Outfeed door
The lock on the outfeed door is loose and works poorly
Vertmax ONE